Table of Contents
Advertisement
5-6 If a Message Appears
These are the main messages that appear on the
machine's display to prompt correct operation. They
do not indicate any error. Follow the prompts and take
action accordingly.
[1■ 2■ 3■ 4■]
Only a small amount of ink remains. Replace the cartridge
indicated by the flashing number with a new cartridge.
[PRESS THE POWER KEY TO CLEAN]
If you're using ECO-SOL MAX ink, this appears when the ma-
chine has been unused for about one month. Switch on the
sub power once a month.
P. 59, "When Not in Use for a Prolonged Period"
[CLOSE THE COVER (FRONT COVER, SIDE COVER
or MAINTENANCE COVER]
Close the front cover, side cover, or maintenance cover. For
safety, the carriage does not operate while a cover is open.
[SHEET NOT LOADED SETUP SHEET]
Load media. This message appears when an attempt to perform
a printing test was made while no media was loaded.
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged fluid collects
in the drain bottle. To clear the message, press
screen appears, go to the [DRAIN BOTTLE] menu and discard
the discharged fluid in the bottle.
P. 46, "Disposing of Discharged Ink"
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain
bottle, then press
[NOW HEATING...]
Wait until the media heating system reaches the preset tem-
perature. Printing starts when
stop printing by holding down
longer while this is displayed. Pressing
ing start immediately, without waiting to reach the preset
temperature.
[REMOVE MEDIA CLAMPS]
This appears when media cutoff is attempted without first
removing the media clamps. Execute media cutoff only after
first detaching the media clamps. Pressing
message is displayed quits cutoff.
[TIME FOR MAINTENANCE]
It is time to clean the heads using the cleaning kit. After verify-
ing, press
.
P. 50, "Cleaning the Heads Using the Cleaning Kit"
106
Chapter 5 What to Do If
. If this
.
lights up. You can
for one second or
makes print-
while this
[TIME FOR WIPER REPLACE]
It is time to replace the wipers. After verifying, press
P. 54, "Replacing the Wipers"
.
Advertisement
Table of Contents
