Table of Contents
Advertisement
2-4 Starting Printing
Getting Ready to Receive Data from a Computer
When you have finished loading media and making the temperature settings for the media heating system, then follow the
steps below. This procedure enables the machine to receive data from the computer and perform printing.
CAUTION
Procedure
Close the front cover.
Make sure
If the light does not come on, lower the loading lever.
Wait until
Make sure the top menu is displayed.
If the top menu is not displayed, press
Printing Is Not Possible in These Situations
The machine does not run when the front cover is open. Also, never open it when printing is in progress.
Doing so interrupts printing.
Data from the computer is not accepted when
Printing does not start until
Data from the computer is not accepted when you are not at the top menu.
Points Which Must Be Observed
Be sure to set the media clamps during printing. Otherwise the edges of the media may warp and
catch on the print heads.
During printing, never touch the media that's already been discharged. Doing so may obstruct media
feed or cause the media to rub against the heads, which may result in a paper jam or damage to the
heads.
40
Chapter 2 Operation
Never touch the print heads while printing is in progress.
The print heads move at high speed. Contact may cause injury.
stays steadily lit.
stops flashing and stays steadily lit.
lights up.
, then press
.
Flashing
Top
menu
W1200mm
Steadily lighted
is dark.
Steadily lighted
Advertisement
Table of Contents
