Table of Contents
Advertisement
4-5 Accommodating Various Kinds of Media
Description
Ink tends to collect on the surface of the heads when you use media prone to buildup of static charge, when the ambient
temperature is low, or when the head height is set to "HIGH. " Under some conditions, this ink may be transferred to the media
or cause dot drop-out. Use this feature at such times. The ink buildup is removed as printing is performed.
When this is set to "PAGE," automatic cleaning is performed every time before printing starts.
When this is set to a value from "10 min" to "990 min," automatic cleaning is performed when the cumulative printing time
reaches the value you set here.
When this is set to "NONE," no automatic cleaning is performed.
Using "PAGE" or a value from "10 min" to "990 min," results in longer printing times. Also, when this is set to a value from "10
min" to "990 min," printing pauses and so colors may be uneven.
P. 67, "Adjusting Head Height to Match Media Thickness"
Default Setting
[PERIODIC CL.]: NONE
Using Sticky Media
Procedure
MENU
SUB MENU
SUB MENU
MEDIA RELEASE
MEDIA RELEASE
DISABLE
W1200mm
SETUP SHEET
Description
Some types of media may tend to stick to the platen. Starting printing with the media sticking to the platen may make normal
media feed impossible and cause the media to jam. When you're using such media, set the [MEDIA RELEASE] menu item
to "ENABLE." This peels off the media if sticking before starting printing. Note, however, that media feed may be unstable
when printing is performed after executing this operation. Leave this menu item set to "DISABLE" unless you specifically
need to change it.
Default Setting
[MEDIA RELEASE]: DISABLE
78
Chapter 4 Feature Reference
Press
Press
Press
Press
Press
Use
ENABLE
Press
Press
.
several times.
.
several times.
.
to select "ENABLE."
to enable the setting.
to go back to the original screen.
Advertisement
Table of Contents
