Roland VersaART RS-640 User Manual page 34

Go around to behind the printer and move the media holders all the way to the left and

right.
Loosen the
retaining screw.
If the diameter of the media core is two inches, detach the end caps from the media holders

and replace them with the included media flanges.
End cap
 Attach the media to the media holders.
Attach the media to the left media holder.
Move the right media holder to the left and attach the media.
Load the media while the left media holder is positioned close to the left edge, as shown in the figure. Also, never secure
the media holder in place before loading the media. Loading media without performing these steps in the proper order
may make smooth media feed impossible or yield poor printing results.
Left media
holder
Move all the way to the left and right.
Media flange
Pull out the clip.
If it is difficult to pull out, use
a pair of pliers or other such
tool.
Fit onto this securely.
2-2 Loading and Cutting Off Media
Loosen the
retaining screw.
Insert the clip.
Line up
the ridges and
grooves
Right media
holder
Chapter 2 Operation 33