Table of Contents
Advertisement
3-3 Cleaning the Heads Using the Cleaning Kit
When the Cleaning Kit Becomes Necessary
Periodic Care and Maintenance
Use the cleaning kit to perform head-cleaning periodically, according to the frequency of use.
When Dot Drop-out or the Like Occur Frequently
When the machine's head-cleaning feature does not correct the problem, clean the heads using the cleaning kit.
If you use up the cleaning kit, purchase a new one from your authorized Roland DG Corp. dealer.
The print heads are components that wear out. Periodic replacement is required, with the frequency
of replacement depending on use. Purchase them from your authorized Roland DG Corp. dealer.
How to Perform Cleaning
Important Notes on This Procedure
To prevent the heads from drying out, finish this procedure in 30 minutes or less.
A warning beep sounds after 30 minutes. At this time, stop work, and follow the procedure in step
page 53 to attach the side cover and the maintenance cover, then close the front cover. Press
to quit the manual-cleaning mode. After that, restart the procedure from the beginning.
Never use any implement other than the included cleaning stick. Cotton swabs or other lint-producing
items may damage the heads.
Never touch the nozzle surface of the heads.
Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush
them.
CAUTION
1.
Change to the print-head manual-cleaning mode.
Remove any media.
MENU
SUB MENU
SUB MENU
MAINTENANCE
MAINTENANCE
CLEANING
OPEN MAINTE-
NANCE COVER
50
Chapter 3 Maintenance and Adjustment
Be sure to perform operations as specified by the instructions above, and never
touch any area not specified in the instructions.
Sudden movement of the machine may cause injury.
Press
Press
Press
Press
Press
Press
.
several times.
.
.
.
.
4.
on
Advertisement
Table of Contents
