Optimizing Printing To Match Media Thickness; Adjusting Head Height To Match Media Thickness - Roland VersaART RS-640 User Manual

4-4 Optimizing Printing to Match Media Thickness

Adjusting Head Height to Match Media Thickness

Procedure

MENU
HEAD HEIGHT

HEAD HEIGHT
LOW
LOW
 High
Height-adjustment lever
Move firmly, until it stops.

MENU
HEAD HEIGHT

W1200mm
SETUP SHEET
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the chance of
contact with the print heads. When you are using such media, adjust the head height to "HIGH." Printing quality when the
head height is set to "HIGH" may be coarser or otherwise lower than when set to "LOW. " If this happens, refer to the pages
indicated below.
 P. 68 "Correcting for Misalignment in Bidirectional Printing," p. 69, "Correcting for Misalignment in Bidirectional Printing More Precisely,"
p. 77, "Preventing Soiling of the Media and Dot Drop-out During Printing"
Press .
Press several times.
Press .
Low (Standard)
Close the front cover.
The print-head carriage moves to the original position, and then the screen shown
in the figure appears.
Press to go back to the original screen.
Open the front cover.
Move the height-adjustment lever to
adjust the head height.
Chapter 4 Feature Reference 67