Accommodating Different Media Types And Conditions; Adjusting Print Head Height To Match Media Thickness - Roland Soljet EJ-640 User Manual

Accommodating Different Media Types and Conditions

Adjusting Print Head Height to Match Media Thickness

Procedure

Press .

MENU
HEAD HEIGHT

HEAD HEIGHT
HIGH LOW

Move the height-adjustment lever to adjust the print head height.
When the lever is moved to the [High] direction, the buzzer sounds twice. When it is moved to the [Low]
direction, the buzzer sounds once.

MENU
HEAD HEIGHT

Press , then
Description
Depending on the media, media may wrinkle or come loose from the platen during printing, increasing the
chance of contact with the print heads. When you are using such media, adjust [HEAD HEIGHT] to "HIGH."
Printing quality when [HEAD HEIGHT] is set to "HIGH" may be coarser or otherwise lower than when set to
"LOW." If this happens, refer to the pages indicated below.
 P. 91, "Correcting for Misalignment in Bidirectional Printing", P. 30, "Performing the Initial Adjustment (Correct-
ing for Misalignment in Bidirectional Printing More Precisely)", P. 101, "Preventing Soiling of the Media and Dot
Drop-Out"
Press several times to display the screen shown
on the left.
Press .
When the screen shown on the left is displayed, open
the front cover.
Height-adjustment lever
Move firmly, until it stops.
Close the front cover.
The print heads move to the original position, and then the screen
shown in the figure appears.
to go back to the original screen.
High
Low
4
95