Configuring Settings To Match The Properties Of The Media; Adjusting Print Head Height To Match Media Thickness - Roland TrueVIS VG2-640 User Manual

Configuring Settings to Match the Properties of
the Media

Adjusting Print Head Height to Match Media Thickness

This adjusts the print head height to prevent media that is wrinkled or comes loose from the platen from contact-
ing the print heads.
You can select the print head height from "LOW", "MIDDLE" or "HIGH". Printing quality when the print head height
is set to "MIDDLE" or "HIGH" may be coarser or otherwise lower than when set to "LOW".
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
3.
Press [▶]. After "NOW PROCESSING.." is displayed, the screen shown below appears.
4.
Open the front cover.
5.
Move the height-adjustment lever to adjust the head height.
When you change the position of the height-adjustment lever, the display screen changes and the buzzer
sounds at the same time.
Position
HIGH
MIDDLE
LOW
MEMO
• Normally move the height-adjustment lever to "LOW." For media that is wrinkled or comes loose from the platen, move the
height-adjustment lever to "MEDIUM" or "HIGH."
• The printing quality degrades as the distance between the media and the print heads increases. Do not move the height-
adjustment lever to "MEDIUM" or "HIGH" needlessly.
6.
Close the front cover.
7.
Press [MENU] to go back to the original screen.
MEMO
• Default setting: LOW
• If degradation of printing quality occurs after raising the print head height, refer to the following page and try optimizing the
quality.
RELATED LINKS
・ P. 139 "Adjust the misalignment of the ink landing position."
144
1. Optimizing the Output Quality
HEAD HEIGHT
LOW HIGH
HEAD HEIGHT
LOW MIDDLE
HEAD HEIGHT
LOW LOW
Display Screen