Configuring Settings To Match The Properties Of The Media; Adjusting Print Head Height To Match Media Thickness - Roland VersaUV LEC2-300 User Manual

Configuring Settings to Match the Properties of
the Media

Adjusting Print Head Height to Match Media Thickness

This adjusts the print head height to prevent media that is wrinkled or comes loose from the platen from contact-
ing the print heads.
Select the print head height from "LOW" and "HIGH". Printing quality when the print head height is set to "HIGH"
may be coarser or otherwise lower than when set to "LOW".
Use [SpLOW] when printing on extremely thin media with a thickness of 0.2 mm (0.008 in.) or less. When using
the [SpLOW] setting, remove the media clamps.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
HEAD HEIGHT
3.
Press [▶]. After "NOW PROCESSING.." is displayed, the screen shown below appears.
HEAD HEIGHT
HIGH
4.
Open the front cover.
5.
Move the height-adjustment lever to adjust the head height.
When you change the position of the height-adjustment lever, the display screen changes and the buzzer
sounds at the same time.
Position
HIGH
LOW
SpLOW
IMPORTANT
When you have moved the height-adjustment lever to "SpLOW," remove the media clamps. The print head coming into contact
with a media clamp may lead to malfunctions.
MEMO
• Normally move the height-adjustment lever to "LOW." For media that is wrinkled or comes loose from the platen during
printing, move the height-adjustment lever to "HIGH."
• The printing quality degrades as the distance between the media and the print heads increases. Do not move the height-
adjustment lever to "HIGH" needlessly.
126
1. Optimizing the Output Quality
LOW
HEAD HEIGHT
LOW
HEAD HEIGHT
LOW
HEAD HEIGHT
LOW
Display screen
HIGH
LOW
SpLOW