Table of Contents
Advertisement
2-2 Starting Printing
STEP 1: Loading the Instrument to be Imprinted
Decide whether you use the vise or table as a retainer depending on the size or shape of the instrument to be
imprinted. The criteria used to select the vise or table are as follows:
Vise The size and shape of the instrument that can be fixed by vise.
Table The instrument has a flat bottom and the size and shape of the instrument that can
not be fixed by vise.
1.
Attach the head cap.
Make sure that preparations for printing are completed.
P. 26, "2-1 Preparing for Printing"
If the head unit is lowered, press the Power/Movement button.
The head moves to the left rear.
Stopper
Knob
Ring
Loosen
Tighten
The center of the knob must
be positioned immediately
above the top of the triangle.
Loosen the head's stopper.
The stopper and ring contact each other.
Fix the head's stopper.
Align the center of the knob with the top of the tri-
angle right below and then secure the stopper.
If you printing as the stopper is loose, the knob might
come off due to vibration.
Chapter 2 Printing
35
Advertisement
Table of Contents
