Table of Contents
Advertisement
6) Installation Instructions (Rim and SecureBolt™)
6.6) Installation of Inside Controller Escutcheon and
Electrical Connections
1. For exterior door applications it is recommended that the gaskets provided
be applied as shown.
2. Remove black cover from the escutcheon with High Security T20 Torx bit provided.
3. Connect the Keypad ribbon cable to the terminal on the controller.
4. Connect the ground wire coming from the Keypad to the insulated spade lug receptacle
coming off the Controller Harness.
5. Complete making all the connections by matching up the connectors being certain all the
connections are secure.
6. Feed excess wire through the inside of the door hole and into outside Keypad escutcheon
cavity, being careful not to pinch wires. Gather excess wire from the controller and position
the excess into the controller escutcheon, being careful not to pinch wires.
7. Insert (2) #10-24 screws through top and bottom of inside escutcheon and thread into
outside escutcheon. Straighten escutcheons and tighten securely, being careful to avoid
pinching wires.
GASKET APPLICATION:
Peel off the adhesive protective paper from gasket.
Feed all wires and harnesses through gasket opening
as shown and firmly press gasket to escutcheon,
aligning edge of gasket with edge of escutcehon.
Keypad Ribbon
Cable
Inside
of Door
Ground
8 Pin
Wire
Molex
Doorwire
Methode
2 Pin
Solenoid
Molex REX
2 Pin
23
24
S1
J3
(
(
J2
NOT
USED
TB1
Ground Terminal
10
C A U T I O N
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
Controller
Escutcheon
Black
Cover
Security Screw
T20 Torx Bit
Keypad harness
(ribbon cable)
1
2
J1
(
J3
NOT
USED
TB1
(
J2
J1
Advertisement
Table of Contents
