Table of Contents
Advertisement
6) Installation Instructions (Rim and SecureBolt™)
6.3)
1.
C
heck cylinder components.
NOTE: Cylinders longer than 1-1/8" (29mm) will require collars.
Refer to Cylinder Collar Chart below.
2. When required, cut cylinder tailpiece.
Correct length is 1/16" to 3/16" (2 to 5mm) beyond cylinder housing cam.
3. Assemble cylinder.
Insert cylinder housing prongs into matching notches of escutcheon.
Pass cylinder tailpiece thru cylinder collar (when required) and slot
in cylinder cam. Fasten cylinder in escutcheon recess or collar
using (2) mounting screws.
(DO NOT OVER TIGHTEN SCREWS).
Rim Cylinder
Cylinder Collar
(when required)
Cylinder Collar Chart
Cylinder length
1-1/8" (29)
1-1/4" (32)
1-1/2" (38)
* Specify Finish
Cam must be positioned as shown
when cylinder tailpiece is assembled
Escutcheon Assembly
Lever is handed, LHR (shown).
NOTE: Lever Return Spring is handed.
Hand of trim cannot be changed without
correct spring.
Lever Return Spring handing can be identified
by the color of the spring:
LHR, part number 651F618 (Red)
RHR, part number 651F628 (Blue)
Cylinder
Ta ilpiece
Collar
None
422F88*
686F98*
6
(2) Cylinder Mounting Screws.
Supplied with cylinder
Cylinder Housing Cam
Advertisement
Table of Contents
