Table of Contents
Advertisement
7) Installation Instructions (Mortise)
7.4) Installation of Outside Trim and Exit Device
Exit Device
1. Seat device against door. NOTE: Device finger must engage
latch bolt lever through slot in door and lock case/cover.
2. Fasten device to trim assembly through holes "B" using (2) 1/4 - 20 pan head
screws.
3. Follow instructions packed with device to secure device to door. Tighten all screws.
TRIM GASKET APPLICATION:
Peel off the adhesive protective paper
from gasket. Feed Trim assembly solenoid
wire harness through gasket opening as
shown and firmly press gasket to
escutcheon, aligning edge of gasket with
the edge of the escutcheon.
Trim
Gasket
"A"
"B"
Solenoid
Wire Harness
"A"
"B"
Device
Finger
16
8 Pin
Molex
Doorwire
2 Pin
Molex
REX
2 Pin
Methode
Solenoid
(2) 1/4-20
Pan Head Screws
Cover
Advertisement
Table of Contents
