Trim Assembly Instructions; Installation Of Outside Trim And Exit Device - Assa Abloy 9800 TCNE1 Series Installation Instructions Manual

6) Installation Instructions (Rim and SecureBolt™)

6.4) Installation of Outside Trim and Exit Device

Outside Trim Assembly
1. For exterior door applications, it is recommended that the Trim Gasket
(provided) be applied as shown below.
2. Route the 2 pin REX (Request to Exit) connector harness into the Trim Assembly cavity in
the door and up thru the door and out the 1/2" diameter Hole "C".
3. Route the Trim Assembly 2 pin connector of the Solenoid wire harness into the trim
assembly cavity in the door and out the 1/2" diameter hole "C". Be careful not to pinch any
wire harness wires.
4. When mounting trim, lift tailpiece to pass through hole on device side. Be sure tailpiece is
in vertical position.
5. Fasten trim assembly through holes "A" using (2) 1/4" – 20 oval head screws and (2) finish
washers. Finger tight only!
Trim Assembly
Solenoid Wire
Harness
Tailpiece
must be
in vertical
position
TRIM GASKET APPLICATION:
Peel off the adhesive protective paper
from gasket. Feed Trim assembly solenoid
wire harness through gasket opening as
shown and firmly press gasket to
escutcheon, aligning edge of gasket with
the edge of the escutcheon.
Inside
of
Door
B
Trim
Gasket
8 Pin
Molex
Doorwire
2 Pin
Molex REX
C
A
A
B
7
C A U T I O N
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
(2) Finish Washers
(2) 1/4 - 20 Oval
Head Screws
2 Pin
Methode
Solenoid
(2) 1/4 - 20 Pan
Head Screws
Cover