Clutch Adjustment - Star Trac eSPINNER Installation And Operation Manual

Preventive Maintenance

Clutch Adjustment

The chain on your bike has been factory set and lubricated. It should not require adjustment initially. Over time, however, you may
need to adjust the tension.
CAUTION: Improper chain adjustment will cause premature wear and may void the warranty.
To adjust chain on eSpinner
1. Using a 3mm Allen Wrench, remove the three screws supporting the
plastic chain guard shroud.
2. Using a 3mm Allen Wrench, remove the four screws supporting the
COG guard cover. (Figure 3)
3. If the torque is not 45 ~ 50 ft-lbs. using a 5 mm Allen Wrench, give
each of the set screws a little clockwise turn. A "little turn" is about
10 degrees. (Figure 3 & 4)
Note:
Be sure and turn all 5 set screws so they have equal pressure
to obtain the proper adjustment. Recheck the torque for differ-
ent positions around the clutch. If it is still not 45 ~ 50 ft-lbs,
repeat the procedure.
The goal is to make all the set screws have the same pres-
sure on the clutch.
4. Test the clutch system for proper operation for normal riding use.
Observe all safety practices.
:
®
Figure 3
Figure 4
Figure 5
COG Cover
Set Screws
47