Assembly and Setup
5. Install Transport Wheels
Parts Needed:
−
Transport Wheels – 2
−
M10 x 1.5 x 45 mm Button Head Screw – 2
−
30 mm spacer - 2
−
20 mm flat washer – 4
−
5 mm hex wrench
♦
With the bike frame securely on level ground insert the spacer into the in-
side of the transport wheel. Position one 20 mm washer on each side of
the spacer and slide the M10 screw through the wheel.
♦
Using the 5 mm hex wrench tighten the M10 screw until snug and torque to
85 lbs-in.
6. Install the Saddle and Seat Slider
Parts Needed:
−
Seat Post
−
Seat slider assembly with Saddle
6A.
♦
Disengage rear pop-pin by loosening then pulling away from the frame. While still holding onto the
pop-pin, install the seat post into the frame and lower it to the lowest position and tighten the pop pin
securely once again.
6B.
♦
Slide the seat slide into the top of the seat post with the saddle
pointed towards the front of the bike.
♦
Rotate the seat slider lock knob as needed so that the slider
clamp is in alignment with the guide rail
♦
There is a locking pin under the saddle that has to be pulled up
as you move the slider into position. Release the pin when the
indicator is within the 0 to 9 range.
♦
Test the seat slide for proper operation and full travel.
Step 5
Step 6A
Step 6B
13