Star Trac eSPINNER Installation And Operation Manual page 17

Assembly and Setup
11. Power Connection
Parts Needed:
−
Coax Cable (not provided)
−
Power Cord
♦
Connect a coax cable to the coax input at the base
of the bike to feed TV signal.
♦
Connect the included power cord to the IEC con-
nector.
♦
Connect the power cord to the appropriate power
outlet.
♦
Turn the ON/OFF switch to the ON position. It
should take approximately 80 seconds for the console to
boot into the eSpinner application. You should see the
'home' screen when the unit is fully booted.
WARNING:
This product will be wired for either 120 VAC nominal power
input OR 230 VAC nominal input. It is factory-equipped with a specific elec-
tric cord and plug to permit connection to the proper electric circuit. Make
sure that the product is connected to a dedicated power line having an out-
let with the same configuration as that of the plug. NO adapter should be
used with this product. If the product must be reconnected for use on a
different type of electric circuit, the reconnection should be made by quali-
fied service personnel
Coax Cable Input
IEC Power Input
ON / OFF Switch
17