Star Trac eSPINNER Installation And Operation Manual page 15

Assembly and Setup
9. Install the Computer Console
Note: This step requires 2 people to properly install the console. Failure to
follow this instruction could result in serious damage to the console.
WARNING – THE POWER CORD MUST BE UNPLUGGED DURING THIS
ASSEMBLY PROCESS OR SEVERE INJURY MAY OCCUR.
Parts Needed:
−
Console support tube
−
Console support sleeve
−
Console
−
5/16 x 18 x .75 pan head screw- 4
−
M6 x 1.0 x 15mm hex bolt - 1
−
M4 x 1.0 x 10 mm Phillips pan head screw - 2
−
Phillips screw driver #2
−
3/16 Allen wrench
−
Rubber mallet – not supplied – optional
−
7/16 open end wrench – 2 – not supplied
9A.
♦
One user should hold the console with the screen facing them. The
other user should carefully guide the 3 cords from the back of the con-
sole through console support plate. The console support plate should
then be attached to the console taking extreme caution to not pinch or
trap any of the cords between the console and the support plate.
♦
With the console plate aligned to the console, screw the 4, 5/16 x 18
pan head screws to the console. Tighten with the 3/16 Allen wrench to
25 in-lbs.
9B.
♦
Next, slide the console support sleeve onto the console support tube.
Then inserts the M6 x 1.0 x 15 mm hex bolt into the bottom of the con-
sole post.
♦
Tighten with the 5 mm hex wrench to 25 in-lbs.
Step 9A
Step 9B
15