Star Trac eSPINNER Installation And Operation Manual page 14

Assembly and Setup
7. Install the Pedals
Parts Needed:
−
Pedals set of two
−
Mutli wrench
NOTE: The pedal shafts are marked "R" and "L". Trying to install the
pedals on the wrong side may damage the pedal and the crank arm
take caution to attach the pedals to the correct side of the bike.
♦
Turn the left pedal spindle counterclockwise when threading into
the left crank arm; turn the right pedal spindle clockwise when
threading into the right crank arm.
♦
Install the pedals on the pedal cranks using a 15mm open-end
wrench and tighten securely.
8. Install the Water bottle Cage
Parts Needed:
−
5 mm Hex Wrench
−
Water Bottle Cage
−
M10 x 1.5, 25 Flat Head Screws - 2
♦
Position the water bottle cage under the support cross bar. Make sure the
closed end of the cage is facing down and towards the rear of the bike.
♦
Carefully thread one of the screws thorough the hole in the water bottle cage
and tighten securely to the frame. Then install the second screw. Tighten
both screws using the 5 mm hex wrench.
♦
Tighten both screws to 85 in lbs using.
14
Step 7
Step 8