Star Trac eSPINNER Installation And Operation Manual page 16

Assembly and Setup
9C.
♦
Attach the 3 wires coming from the console to the 3 mating wires coming
from inside the console support tube.
♦
Attach the ground wire from the console support tube to the
wire coming from inside.
♦
To securely connect the coax cable tighten the connectors finger tight.
Using 2, 7/16" open wrenches attach one wrench to the female hex and
one wrench to the console connector end, tighten a quarter turn. Move
the wrench to the connector on the frame side of the connection and
tighten a quarter turn.
♦
While one person is still holding the console, carefully thread the
cess wires into the open end of the eSpinner console support tube. You
must take care to make sure that the wires are not pinched or severed
during the next step.
♦
With the wires properly stored, begin to slide the console and the con-
sole support sleeve into the console support tube.
♦
The plastic sleeve is a tight fit with the console support tube and will
need to be firmly pressed into place. You can gently use a rubber mallet
to assist the console support sleeve into place.
9D.
♦
Once the console support sleeve is installed, secure the sleeve to the
frame with the 2 M4 x 1.0 x 10 mm Phillips pan head screws and the
included Phillips head screw driver.
10. Leveling the Bike
Parts Needed:
−
Multi-Wrench
♦
Move the bike to the a clear, level surface area where you plan to oper-
ate the unit. There are four leveling feet on the bottom of the eSpinner
that can be adjusted to securely level the product. The eSpinner re-
quires approximately 4' x 7' of open floor space to safely operate the
bike.
16
ground
ex-
Step 10
Step 9C
Step 9D