Assembly - Star Trac eSPINNER Installation And Operation Manual

Assembly and Setup

ASSEMBLY

WARNING – DO NOT USE POWER TOOLS or POWER DRIVE ASSEMBLY TOOLS DURING THE AS-
SEMBLY OF THE eSPINNER. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY DAMAGE THE
PRODUCT DURING ASSEMBLY WHICH IS NOT COVERED UNDER THE STAR TRAC WARRANTY.
Following these steps in order will minimize the build time and ensure proper assembly.
1. Install the Rear Leg
Parts needed:
−
One leg assembly
−
M10 x 1.5 x 60 mm Button Head Screw – 2
−
M10 x 1.5 x 65 mm Button Head Screw – 2
−
20 mm Flat Washer – 8
−
M10 x 1.5 Nyloc Hex Nut – 4
−
5 mm Hex Wrench
−
Multi-wrench
♦
Lift up the rear of the bike frame and place the rear leg assembly
in position under the frame, aligning the holes in the leg with the
holes in the frame.
♦
Position the leg so the thicker end faces toward the front of the
bike
♦
Using the 5mm Hex wrench and the 13mm multi-wrench insert 2-
M10X60mm (rear-most holes) and 2-M10X65mm (front-most
holes) button head screws, nuts and washers (under bolt head
and nut), to secure the rear leg assembly to the frame.
♦
Tighten all hardware securely using a torque wrench to 85 in-lbs.
2. Install the Rear Pop Pin
Parts needed:
−
Pop pin
−
21 mm open wrench
♦
Carefully thread the pop pin assembly into
the open hole on the rear of the bike frame.
♦
Using the 21 mm open end wrench, tighten
the pop pin to the frame to 50 in-lbs.
Step 1
Step 2
11