Assembly And Setup - Star Trac Turbo Trainer Owner's Manual

A
ssembly &
Use the following procedures to unpack and assemble your Turbo Trainer manufactured by Star Trac
UNPACKING
Position the shipping carton so the "Heavy End" logo is located at the bottom. Open the top of the carton and fold back all four flaps.
Carefully tilt the box forward so that the box may be lifted to expose the bike. Remove all parts from the shipping carton and foam inserts,
and verify that the following parts are included in your shipment:
NOTE: All tools required to assemble the bike are included within the packaging, except for a Rubber Mallet, which is recommended
when assembling the pedals onto the bike.
Turbo Trainer Parts List
Description
Main Frame Assembly
Console Mast
Console
Left and Right Arms
Left and Right Foot Stand
Left and Right Foot Pedals
Seat Post
Take time now to enter your Turbo Trainer serial number in the space below (serial number is located on underside the bottom rear cross
member).
If parts are missing, or if you have any operational questions, please call Star Trac's Service department at (800) 503-1221.
Have your serial number ready.
Serial No._____________________________________________
NOTE: If you are missing any of the parts listed above, inspect the packing material and the box for items that may have been
overlooked.
If parts are missing, or if you have any product questions, please call Star Trac's Service Department at (800) 503-1221, please have
your bike's serial number ready.
CAUTION: Damage to the bike during assembly is not covered as part of the limited Star Trac warranty. Take care not to drop or lean the
bike on the handle bar pop-pin. Carefully stand the bike up in the normal upright position on a stable surface so it will not tip over during
assembly.
S
etup
PARTS LIST
AND
TURBO TRAINER Manufactured by STAR TRAC OWNER'S MANUAL |
Qty. Description
1 M8x15mm Button Head Bolt
1 M8x16 O.D. Flat Washer
1 M8x20mm Socket Head Cap Screw
2 M8x25mm O.D. Flat washer
2 M24x1.5 Hex Jam Nut
2 M8x20mm Button Head Bolt
1 M8x1.25x12mm Hex Screw
M4x10mm Socket Head Cap Screw
M4x10mm Phillips Pan Head Form Screw
.
Qty.
14
14
2
2
2
4
2
2
2
13