Water Supply - GIRBAU HS-6013 Installation Instructions Manual

3.2. Water supply

IMPORTANT!
The local or national regulations concerning the water supply system in the country where the washing
machine is installed must be followed.
Hoses and pipes should be flushed through before being connected to the machine.
Install at each water supply and in an accessible location, a mechanically interlocked water valve.
In those premises using water containing impurities, it is recommended to install a filter at the main water supply
inlet.
Refer to technical specifications on the INSTALLATION SPECS, section 1.4.
Assembling the filters and their connection (Fig. 3.4)
Insert filter C and washer B inside each of the water inlet
couplings D.
Assemble the couplings to the solenoid valves A.
Place the E seals on the water inlet hoses F.
Put the water inlet hoses on the solenoid valve couplings.
Open the manual valves and check for leaks in the
installation.
Arrangement of the hoses
The inlets are identified by the label posted at each inlet (Fig. 3.5).
The washer mixes hot and cold water according to the temperature programmed. The use of hot/cold water
allows the machine to gain time and effectiveness in its washing programs.
The cold water must ALWAYS be
Inlet 1
connected. The hose is marked with a
blue line.
Connect hot water. The hose is marked
Inlet 2
with a red line.
(This option is only available for Inteli
Control). Connect cold or hot water
Inlet 3
according to the washer configuration.
The hose is marked with a red line.
DO NOT CONNECT THE HOT WATER TO INLET 1. THIS INLET DOES NOT HAVE A TEMPERATURE
CONTROL SYSTEM.
DO NOT CONNECT THE HOT WATER TO INLET 3 IF IT IS NOT CONFIGURED AS A DUAL HOT WATER
INLET FLOW.
INCOMPLIANCE OF THIS PRECAUTION CAN CAUSE FABRIC DAMAGE.
For a correct operation of the washing machine, the hot and cold water inlets must receive an
uninterrupted supply at all times.
If there is no hot water supply, connect cold water or cold softened water to inlet 2.
INTELI control washing machines, ADAPT THE WASHER CONFIGURATION to operate with cold water.
Installation
28
Fig. 3.4
Fig. 3.5
Cod.nº 429043
Rev. 15/1215