CYBEX XP4040 Installer/User Manual page 74

The System Identification Menu
From the Chassis ID Menu, press the Down button to reach the System
Identification Menu.
This menu displays the type of module installed in each of the XP4400's nine
available slots, labeled A through I. An "R" indicates a receiver module is
installed, a "T" indicates a transmitter module.
For more detailed information about your installed modules, press the Right
button. The following menu appears:
Hardware, firmware and serial numbers are displayed for the module located in
slot A of your XP4400 unit. Press the Up and Down buttons to cycle through the
information for all nine slots. When you are finished viewing this information
press the Left button to return to the System Identification Menu.
The System Status Menu
From the System Identification Menu, press the Down button to reach the
System Status Menu.
If the red LED on your XP4400's front panel is blinking, this menu will show
you where the problem lies. Once you leave this menu, via the Left button, the
blinking light will change from blinking to solid until the problem is resolved.
The LED will go off when the problem is resolved. If a second problem occurs,
the light will begin blinking again.
For more detailed information about the fan assemblies or the power supply
output voltages, press the Right button. The following menu appears:
Press the Up and Down buttons to cycle through the information for the upper
and lower power supplies and fan assemblies. When you are finished viewing
this information, press the Left button to return to the System Status Menu.
***Slot in Use***
A B C D E F G H I
R T T
Scan On
Slot A: type
Hardware: ###
Firmware: ###
Ser.No #: ###
*** SYSTEM STATUS ***
FAN modules OK!
PSU1 : OK
PSU2 : OK
+5V:ok +12V:ok
-5V:ok -12V:ok
D5V:ok AC:ok DC:ok
lower power supply
68