Transmitter/Receiver Board And Expansion Cable Installation - CYBEX XP4040 Installer/User Manual

Transmitter/
Receiver Board
and Expansion
Cable Installation
Installing the
transmitter/receiver
boards
Connecting the
expansion cables
To install your transmitter/receiver boards in your XP4000 Series units, follow
the steps below:
1. Position the unit so that the rear panel is facing you, and choose an
available slot.
2. Remove the panel covering the available slot by unscrewing the two
Phillips-head screws on the rear of the unit that hold the panel in place.
3. Locate the two Phillips-head screws on the transmitter or receiver board,
located above and below the two connectors. Back these screws out until
they are flush with the transmitter/receiver board cover plate.
4. Slide the transmitter or receiver board gently into the open slot of the
XP4000 Series unit until the connectors line up flush with the back of the
unit. See the diagram below.
(XPST SHOWN)
5. Retighten the holding screws completely. DO NOT overtighten.
Follow the above procedure for every transmitter/receiver pair in your system.
To connect your expansion cables, follow the steps below:
1) Locate the expansion cable with the length that matches the jumper
settings of your first transmitter/receiver pair.
If you are using the XPXT and XPXR Transmitter and Receiver Boards
2) Connect the female 26-pin connector on the expansion cable into the male
26-pin connector on the transmitter. (Remember to select the correct port
for your configuration.)
3) Connect the male 26-pin connector on the expansion cable into the female
26-pin connector on the receiver. (Be sure and connect to the same port on
transmitter and receiver.)
59
(XPXT SHOWN)