CYBEX XP4040 Installer/User Manual page 25

Installing the computer interface modules (XPAB and XPAC)
1. Position the XP4000 Series unit so that the rear panel is facing you.
Choose an available slot. An available slot will have a solid panel cover-
ing the opening, with no connectors showing through it.
NOTE: For front access models, the LCI module, at the far left of the
unit (viewed from rear), is covered by a solid panel but IS NOT an
available slot. Only the LCI module is installed in this slot.
AC INPUT
90-240 VAC, 47- 63 Hz
1 AMP FAST BLOW
250 VAC
2. Remove the panel covering the available slot by unscrewing the two
Phillips-head screws on the rear of the unit that hold the panel in place.
3. Slide the new computer interface module gently into the open slot of
the unit until the 44-pin connector lines up flush with the back of the
unit. See the diagram below.
4. Retighten the holding screws completely. DO NOT overtighten.
5. Fill out the Configuration Chart in Appendix A for each module as you
install it.
Follow this procedure for every computer interface module in your system.
LCI MODULE (FRONT ACCESS MODEL ONLY)
LCI MODULE (FRONT ACCESS MODEL ONLY)
AVAILABLE SLOTS FOR OPERATION MODULES AVAILABLE SLOTS FOR OPERATION MODULES
19