CYBEX XP4040 Installer/User Manual page 134

SYMPTOM ACTION
The Channel
Recheck the jumper settings on the XPAC/XPAB module. See
is Selected,
Chapter 3.
but No Video
Re-verify that the VGA connector on the computer input cable is at-
is Present
tached to your video card
Recheck the DIP switch settings on the XPAC/XPAB module. See
Chapter 3 for details.
Video Can
Recheck the jumper settings on the XPAC/XPAB module. See
Be Seen but Chapter 3.
is Distorted,
Recheck the DIP switch settings on the XPAC/XPAB module. If
Discolored
your monitor uses sync on green, make sure it is set accordingly.
or Out of
See Chapter 3 for details.
Sync.
Ensure your monitor is capable of the desired resolution.
Keyboard
Re-verify that the selected computer is turned on.
Does Not
Verify that the keyboard is communicating with the switch by going
Work
into Command Mode.
Check the keyboard connection to the unit. Make sure it is secure.
Only 1 keyboard can be plugged into a user console at a time. If
multiple keyboards are attached to a single local or secondary
console, remove all but one of them.
Check the status of the Scroll Lock. When mixing platforms, some
keys are "remapped" using the Scroll Lock to provide all platform-
dependent keys. See "Multiplatform Keyboard Translation" in
Chapter 7.
Mouse Does
Ensure that the mouse connection to the unit is secure.
Not Work
Only 1 mouse can be plugged into each user console. If multiple
mice are attached to a single console, remove all but one of them.
Enter the <CM>M+<Enter> sequence to re-enable the mouse.
See Chapter 7, "Keyboard Control", for details.
Ensure you have selected a channel with control of a serial device.
Serial Device
Does Not
Recheck the serial device connection to the unit and make sure it
Work
is secure.
Check communication port settings on both the computer and the
serial device, such as baud rate, parity, start and stop bits, and flow
control.
128