CYBEX XP4040 Installer/User Manual page 24

Configuring the DIP Switch (XPAC, XPAB and XPAL)
The DIP switch is used to configure three different features: video options and
sync, keyboard/mouse time-out and keyboard translation options (Mac only).
The diagram below shows the DIP switch, the positions used to configure each
of these features, and the default settings.
Reserved
Video Options
Your XP4000 Series unit is factory set for PC video. No changes are needed
to switches 1 through 3 for normal PC video.
By default, a computer's video will be displayed for any console user that
switches to that channel. If you do not want a computer's video to be displayed,
you can disable the video for that channel. Additionally, if you are only
running your keyboard and mouse through the XP4000 Series unit, and your
video is independent of the system, you should select the option to disable the
video. See the table below.
Switch 1 Switch 2
Off Off
On On
Video Sync - XPAB only
Your XPAB card will attempt to automatically detect the sync for your
monitor. In some unique instances it will obtain the opposite of the settings.
Switching S7 to the on position will correct this. See the table below.
Switch 7
Off
On
Keyboard/Mouse Time-out
While multiple consoles can view a computer's video at the same time, only
one station can have keyboard and mouse control at a time. The amount of time
that a console's keyboard and mouse must be inactive before another console
can take control is called the time-out. See the table below for the available
time-outs that can be configured.
Switch 4
Off
On
Note: Once your XPAC/XPAB module has been installed, you can change the
DIP switch setting at any time through a simple hot-key sequence. See Chapter
9, Advanced Operations for more information.
Keyboard/Mouse
Timeout
Translation
Switch 3
Off Normal video (default)
On Video disabled
Sync Mode
Autodetect (default)
Reverse Autodetected Sync
Time
1 second (default)
10 seconds
18
Video
7 8
Function