Keyboard Switching With Different Cybex Products - CYBEX XP4040 Installer/User Manual

Keyboard
Switching with
Different Cybex
Products
If you have an AutoView Commander product in your system, you will need
to make use of the alternate command mode hotkey sequences available with
your unit. This will allow the system to correctly determine which unit to
change the channel on.
For example, suppose that your configuration includes four computer channels:
C, E, G and J. On computer channel J, you have attached an AutoView
Commander which is controlling three computer channels - A through C. You
want to switch to channel B on the AutoView Commander.
User Console 1
Autoview
Commander
First, you must change the command mode hotkey sequence for the XP4000
Series unit to one of the alternates to differentiate it from the AutoView
Commander's default sequence. Use the alternate sequence to change to
computer channel G. Now, use the default sequence to switch to channel B
on the AutoView Commander.
Once you have changed the hotkey sequence to an alternate, it will remain the
active sequence until you change it again. There are four alternate sequences
to choose from. Command mode hot-key sequences can be changed at any
time. The command lines on the following page illustrate the proper format to
change your hotkey sequence. For systems with On Screen Display, see
Chapter 8.
Computer B
Computer A
112
User Console 2
Computer C (4XP)
Computer E (4XP)
Computer G (4XP)
Computer C