CYBEX XP4040 Installer/User Manual page 20

For Sun keyboard and mouse
1. Your user interface cables for these peripherals will be labeled either
CWSU-x or CWSUF-x, depending on the options you ordered. Use the
cable diagrams below to locate the correct cable.
VGA VIDEO
CWSU- x CABLE
2. At your secondary console, plug your Sun keyboard/mouse and VGA
monitor connectors into the two matching connectors on the user inter-
face cable.
If you have the CWSUF-x series cable, you will have three additional
connectors: two small connectors for a microphone and speakers, and a 9-
pin D-shaped serial connector for a serial port. The microphone connector
is denoted by a blue band around its cable. Plug your peripheral connec-
tors into the matching connectors on the user interface cable.
3. Attach the user interface cable to the unit by plugging the 62-pin connec-
tor into the rear of any available secondary console module. Ensure that
the connector is firmly seated, then tighten the thumbscrews.
NOTE: You may use your Sun monitor with an XP4000 Series unit if it will
function with all of your attached computers/workstations. See 'Using Non-
multisync Monitors' later in this chapter.
KEYBOARD/
MOUSE
MICROPHONE
14
VGA VIDEO
KEYBOARD/MOUSE
SPEAKERS
(blue band)
SERIAL PORT
CWSUF- x CABLE