Lcd Display Operation - CYBEX XP4040 Installer/User Manual

Xp4000 series switch
Table of Contents

Advertisement

LCD Display
Operation
The XP4400 front panel supports a 4x20 character LCD display which is used
to configure and display status for your XP4400 unit. As soon as you power on
your XP4400 unit, the Idle Display Menu appears as shown below:
The Contrast Menu
If your display is either too bright or cannot easily be seen, press the Right
button to reach the Contrast Menu.
Use your Up and Down buttons to increase or decrease the contrast of your
display. Press the Right button to save the changes and return to the Idle
Display Menu. Press the Left button to return to the Idle Menu without saving.
If neither button is pressed within 5 seconds of your last change, you will
automatically return to the Idle Display Menu without saving the changes.
The Chassis ID Menu
From the Idle Display Menu, press the Down button to reach the Chassis ID Menu.
The first time you power on your XP4400 unit, the Chassis ID will read as "0".
NOTE: You must change this to a valid system chassis ID before integrating
the XP4400 into your configuration.
To set or change your chassis ID, press the Right button. The following
menu appears:
The old ID is shown. Press the Up and Down buttons to set a new chassis ID for
your XP4400 unit. Press the Right button to save the changes and return to the
Chassis ID Menu. Press the Left button to return to the Chassis ID Menu
without saving.
----XP 4400----
Chassis 000
www.cybex.com
DISPLAY CONTRAST
0
100%
########
****EDIT
MODE****
Chassis ID
0
Chassis ID
->new ID ###
old ID ###
****EDIT
MODE****
67

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xp4010Xp4080Xp4400

Table of Contents