CYBEX XP4040 Installer/User Manual page 41

Configuring the DIP Switch
The DIP switch is used to configure three different features: video options and
sync, keyboard/mouse time-out, and keyboard translation options. The diagram
below shows the DIP switch, the positions used to configure each of these
features, and the default settings.
Reserved
Video Options
Your XP4000 Series system is factory set for VGA video. No changes are
needed to switches 1 through 3 for normal VGA video. Similarly, if your HP
uses BNC video and your monitor supports sync on green, no changes are
required. However, if your HP uses BNC video and your monitor supports
horizontal and vertical sync only, configure your system according to the table
below.
By default, a computer's video will be displayed for any console user that
switches to that channel. If you do not want a computer's video to be displayed,
you can disable the video for that channel. Additionally, if you are only
running your keyboard and mouse through the XP4000 Series unit, and your
video is independent of the system, you should select the option to disable the
video. See the table below.
Switch 1 Switch 2
Setting Setting
Off Off
On On
Off Off
Keyboard/Mouse Time-out
While multiple consoles can view a computer's video at the same time, only
one station can have keyboard and mouse control at a time. The amount of time
that a console's keyboard and mouse must be inactive before another console
can take control is called the time-out. See the table below for the available
time-outs that can be configured.
Switch 4
Setting
Off
On
Note: Once your XPAC/XPAB module has been installed, you can change the
DIP switch setting at any time through a simple hot-key sequence. See
Chapter 9, Advanced Operations for more information.
Keyboard/Mouse
Timeout
Translation
Switch 3
Setting
Off Normal video (default)
On Video disabled
On Use sync on green to generate horizontal
and vertical sync
Time
1 second (default)
10 seconds
35
Video
7 8
Function