CYBEX XP4040 Installer/User Manual page 148

Key Sequence
<CM>KMnnn<Enter>
<CM>KM0<Enter>
<CM>TG<Enter>
<CM>TH<Enter>
<CM>T+ [channel list] <Enter> Enables the Broadcast Add Channel (+) command
<CM>T- [channel list] <Enter>
<CM>FOLLOW Addr <Enter>
<CM>FOLLOW+<Enter>
<CM>FOLLOW-<Enter>
<CM>SWAP Addr <Enter>
<CM>SWAP+<Enter>
<CM>SWAP-<Enter>
<CM>X Addr <Enter>
<CM>SAVE<Enter>
<CM>SW= n <Enter>
<CM>SW+<Enter>
<CM>SW-<Enter>
<CM>CHASSIS= n <Enter>
<CM>SUN= n <Enter>
<CM>SUNI= n <Enter>
Action
Sets the highest unit address that the system will scan
through during a session. Substitute nnn with a value from
1 to 254. Required for expansion systems only.
Resets scanning to include channels in the local unit only.
Enables the Broadcast Go command
Enables the Broadcast Halt command
Enables the Broadcast Remove Channel (-) command
Sets the address of the leader console to be followed
Enables Follow Mode
Disables Follow Mode
Sets the address of the console to be swapped with
Enables Swap Mode
Disables Swap Mode
Places a computer channel in Privacy Mode
Saves user console configuration (i.e. Broadcast Mode,
DIP switch settings, KeyScan channels) settings to
permanent memory. Any configuration changes not saved
will not be retained after a power reset.
Overrides DIP switch settings on XPAC/XPAB computer
interface modules. Sets the bank of switches (1-8) to a
user specified ON/OFF combination. To determine the
correct DIP switch code for your system ( n ), refer to
Appendix H.
Enables override of DIP switch settings.
Disables override of DIP switch settings.
Changes the unit address of the local unit to n (0-254).
Used in expansion systems only. If your chassis does not
contain either an XPXT or an intelligent power supply
(XPPS-2), you will need to use this command to assign the
chassis a unit address. Valid chassis addresses are
necessary for proper upgrading of expansion systems.
Foreign Sun Workstations Only Sets all XPAC/XPAB
computer interface modules attached to Suns to emulate
country-specific key codes. To determine the correct code
for your system ( n ), refer to your Sun workstation
documentation and Appendix G.
Foreign Sun Workstations Only Sets the current XPAC/
XPAB computer interface module (Sun only) to emulate
country-specific key codes. To determine the correct code
for your system ( n ), refer to your Sun workstation
documentation and Appendix G.
142