Using Non-Multisync Monitors - CYBEX XP4040 Installer/User Manual

Using
Non-multisync
Monitors
Using your SGI, RS/6000 or HP Workstation Monitor
1. You may use your SGI, RS/6000 or HP workstation monitor with an
XP4000 Series unit if it will function with all of your attached computers/
workstations. In order to connect your monitor, you will need a video
adaptor from Cybex. These devices adapt the VGA video output to your
workstation monitor's input. If you do not have one of the adaptors listed
below, contact our Sales Department.
Monitor Connector Type
13W3 (SGI)
13W3 (RS 6000)
Using your Macintosh Monitor with an XP4000 Series unit
1. You may use your Macintosh monitor with an XP4000 Series unit if it will
function with all of your attached computers. In order to connect this type
of monitor, you will need a VAD-16 video adaptor from Cybex. This
device adapts the VGA video output to your Mac monitor's input. If you
do not have this adaptor, contact our Sales Department.
2. Follow the instructions above for the installation of a Macintosh keyboard
and mouse, making sure to attach the VAD-16 adaptor between your user
interface cable and your Mac monitor cable.
Using your Sun Monitor with an XP4000 Series unit
1. You may use your Sun monitor with an XP4000 Series unit if it will
function with all of your attached computers/workstations. In order to
connect this type of monitor, you will need a VAD-13 video adaptor from
Cybex. This device adapts the VGA video output to your Sun monitor's
input. If you do not have this adaptor, contact our Sales Department.
2. Follow the instructions above for the installation of a Sun keyboard and
mouse, making sure to attach the VAD-13 adaptor between your user
interface cable and your Sun monitor cable.
Changing XPDU settings for Non-PC Monitors
In some cases you may not see video the first time you power up a Sun or Mac
Monitor attached to an XPDU. If this happens:
1. Hold down the <CTRL><ALT><Shift> and <M> keys at one time.
2. The monitor will begin to cycle through settings. When you see video on
your screen, press the <ENTER> key.
Your monitor should begin to work normally.
BNC
3C3
15
Adaptor Type
VAD-19
VAD-14
VAD-20
VAD-22