CYBEX XP4040 Installer/User Manual page 130

There are two methods of operating the reboot function of the XPRB: direct
addressing and associated addressing. Direct addressing allows you to cycle the
power of a specific Power Port on an XPRB. See Figure 10-1 below.
The following key sequence is used for direct address rebooting.
Key Sequence
<CM>REBOOT Addr[n] <Enter>
Associated addressing allows you to associate a Power Port on an XPRB with
a computer interface module within your system. Similar to direct addressing,
associated addressing allows you to cycle the power of a specific Power Port on
an XPRB. This method allows you to associate, or link, the Power Port number
to a specific computer channel address. So, once you have made the link, you
only need to remember a computer's channel address to cycle the power. See
Figure 10-1. The key sequences below are used for associated addressing.
Key Sequence
<CM>XPRB Addr1[n] = Addr2 <Enter>
XPRB
(CHANNEL C)
XPRB
(CHANNEL C)
Action
Reboots the device connected to the XPRB at Addr .
The value, n (1-6), indicates Power Port on XPRB.
After pressing <Enter>, type 'Yes' and press <Enter>
again to confirm the reboot. Pressing any key
sequence besides 'Yes' will abort the reboot.
Action
Associates the XPRB at Addr1, Power Port n
with the computer interface module at Addr2.
ASSOCIATED ADDRESSING: POWER PORT 1
IS ASSOCIATED WITH THE COMPUTER
ATTACHED TO CHANNEL H.
XPAC
(CHANNEL H)
DIRECT ADDRESSING: NOW, POWER
PORT 1 IS NOT ASSOCIATED WITH ANY
COMPUTER IN THE SYSTEM. TO CYCLE
THE POWER ON THE MODEM, DIRECT
ADDRESSING IS REQUIRED.
FIGURE 10-1
124