Table of Contents
Advertisement
Installing the
XPIQ and XPSI
Modules
Attaching
Terminals to
the XPSI
Module
1. Position the XP4000 Series unit so that the rear panel is facing you. Choose
an available slot. An available slot will have a solid panel covering the
opening to the unit, with no connectors showing through it.
NOTE: For Front Access models, the LCI module, located to the far left of
the unit (viewed from rear), is covered by a solid panel but IS NOT an
available slot. Only the LCI module can be installed in this slot.
2. Remove the panel covering the available slot by unscrewing the two
Phillips-head screws on the rear of the unit that hold the panel in place.
3. Slide the new module gently into the open slot of the XP4000 Series unit
until the connector(s) line up flush with the back of the unit. See the
diagram below.
4. Retighten the holding screws completely. DO NOT overtighten.
Follow the above procedure for every XPIQ and XPSI module in your system.
The XPSI module has four ports available for attaching terminals, hubs, routers
and other serial-based equipment. To attach this equipment to the XP4000
system, follow the steps outlined below.
1. You will need a Category 5 UTP cable to connect your XPSI to your
equipment. Cybex provides these cables, with an RJ45 connector on each
end, in lengths from 10 to 150 feet. (C5T-10, C5T-25, C5T-50, C5T-100,
C5T-150). We recommend using Cybex cables in your XP4000 configuration.
2. Plug one end of your Cat 5 cable into the first available port on the rear of
your XPSI module.
3. Depending on the type of equipment you are attaching to the XPSI, you will
need an adaptor to attach to the remaining end of the Cat 5 cable. A list of
common adaptors and their Cybex part number is shown on the following
page. Select the adaptor that meets your requirements.
4. After attaching the appropriate adaptor, connect the remaining end of the
Cat 5 cable to the equipment you wish to attach to the XP4000 system.
40
Hide quick links:
Advertisement
Table of Contents
