CYBEX XP4040 Installer/User Manual page 66

4) Tighten the thumb screws on each end of the extension cable, and repeat steps 1-
4 for every expansion cable in the system.
If you are using the XPST and XPSR Transmitter and Receiver Boards
2. The connectors for the XPST consist of two banks of three modular connectors
each.(See diagram below) Connect one end of the Category 5 UTP cable to the
video port on either bank of connectors on the transmitter. Connect the other
end of the cable to the video port on the receiver.
3. Repeat the above process with the keyboard/mouse and multimedia cables until
all banks are connected. Be sure that the cables on the transmitter connect to
the same functions on the receiver.
You do not have to connect the multimedia cables if you aren't using the
multimedia capabilities.
You will know when your expansion cables are installed properly by observing
the LEDs on the front panel of the unit. If you are using a Rear Access model
of the XP4040 or the XP4080, your cables are installed correctly in Bank 2
when the upper (amber) LED for the corresponding transmitter board is lit. If
your cables are installed correctly in Bank 1, the lower (green) LED will be lit.
If you have installed transmitters with conflicting unit addresses in the same
unit, the amber and green LEDs will flash alternately.
Functions
Multimedia
Keyboard, Mouse
Video
Multimedia
Keyboard, Mouse
Video
If you are using the front access model of the XP4040, the green LED will light when
the cable in either port is installed correctly. Similarly, if you have transmitters in the
same unit with conflicting unit addresses, the green LED will flash.
Pair 3
PR2 PR1 PR4
+ - + - + - + -
Bank 2
T R T R T R T R
1 2 3 4 5 6 7 8
Bank 1
60
Standard 4-Pair
Wiring Color Codes
Pair 1 T White/Blue
R Blue/White
Pair 2 T White/Orange
R Orange/White
Pair 3 T White/Green
R Green/White
Pair 4 T White/Brown
R Brown/White
CABLE PINOUT
(BELDEN 1583A OR EQUIVALENT)