Figure 1-15 Removing The Existing Board From Its Bracket - Silicon Graphics 1400 Server Family Maintenance And Upgrade Manual

Chapter 1: Working Inside the System
30
1
3
Removing the Existing Board from its Bracket
Figure 1-15
The components shown in Figure 1-15 are:
1. Screws that attach the existing board to the bracket
2. Existing PSB
3. Bracket
To correctly position the new board inside the chassis:
1. Insert the NON-BRACKET END, then push the other end down so that the two
slots in the bracket slide over the corresponding tabs on the chassis wall. Figure 1-16
shows an example.
2. Use the two screws you removed earlier to attach the bracket to the chassis.
2