Attaching The Front Bracket; Figure 4 Fl/Rr Bracket Orientation - Silicon Graphics 1450 Mounting Instructions

SGI 1450 Server Mounting Instructions

Attaching the Front Bracket

8
To attach the front bracket to the slide assembly, follow these steps:
1. Remove two #8-32 x 1/2 long pan-head screws, two washers, and two lock nuts
from the kit.
2. Extend the intermediate member out from the outer member so that the hole at the
front end of the outer member is visible through a rectangular hole in the
intermediate member. Item B in Figure 5 shows the direction in which you must
extend the intermediate member.
Figure 4 shows how the FL/RR bracket is oriented and how the slide rail assembly is
extended.
A
B
Figure 4 FL/RR Bracket Orientation
A. Front Left The front left bracket is labeled FL/RR.
Bracket
B. Lower Tongue The correct orientation of the lower tongue of the bracket safety
latch is shown.
C. Extended Slide The intermediate member is extended so that the rectangular hole
Assembly in the screw hole in the outer member is centered in the rectangular
hole of the intermediate member.
C
007-4242-001