Installing The Baseboard; Figure 2-1 Removing The Baseboard - Silicon Graphics 1400 Server Family Maintenance And Upgrade Manual

Figure 2-1 Removing the Baseboard

Installing the Baseboard

1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Place the EMI gasket over the I/O connectors on the baseboard.
3. Position the board over the two snap-in standoffs and threaded standoffs inside the
chassis; slide it carefully toward the rear of the system until the I/O connectors
protrude through the back panel.
4. Press the board onto the snap-in standoffs, then insert one screw through one of the
mounting holes of the board and into a threaded standoff. Do not tighten the screw
until the next step.
Baseboard
35