Chapter 2: Upgrading Baseboard Components
52
Installing a VRM
Use Figure 2-10 and the following steps to install a VRM on the system baseboard:
1.
Read and observe the ESD and other warnings listed in the previous section
"Removing a VRM" on page 51.
2. Remove the VRM from its protective package.
3. Carefully insert the VRM in the connector on the baseboard. See Figure 2-10 for an
example.
Make sure you do not bend the connector pins.
Note:
4. Push down firmly on both ends of the VRM until the ejector levers of the connector
snap into place, locking the VRM in the connector.
5. Reinstall the rear foam cover over the electronics bay.
6. Reinstall the access cover using the original screws.
1
3
Figure 2-10
Installing a VRM
The components shown in Figure 2-10 are:
1.
VRM connector on baseboard
2. VRM
3. Ejector lever
2
Need help?
Do you have a question about the 1400 Server Family and is the answer not in the manual?