Connect - Kollmorgen SERVOSTAR 640 Instruction Manual

Setup
9.3.2

Connect

l
l
l
If a fault code (
in the display, you will find the description on page 94ff. If there is fault, fix the
problem.
Frequent causes:
Click OK to remove the error message. Detect and remove the error source. Restart the software.
82
Connect the interface cable to a serial interface on your PC and to the serial interface X6 of
the servo amplifier. USB to serial converter can be used optionally.
Switch on the 24 V power supply for the servo amplifier.
Wait about 30 seconds, until the front display of the servo amplifier displays the current
classe (e.g. for 40 amps). If the power supply voltage is switched on, too, a leading
P is displayed (e.g.
) or a warning (
Double-Click the DRIVE.EXE icon on your Windows desktop to start the software.
- wrong interface chosen
- wrong connector chosen at the servo amplifier
- interface is used by another software
- 24 V auxiliary voltage for the servo amplifier not working
- interface cable broken or wrong wiring
12/2010
for Power, 40 amps).
) or a status message (./_ / E/S) appears
You can work offline or online with .
Work ONLINE now. Select the interface where the servo am-
plifier is connected to.
The software tries to communicate with the
drive and to upload the parameters. If it's
not successful, you receive this error mes-
sage.
®
SERVOSTAR 640/670 Instructions Manual
Kollmorgen