Control Module - Chery automobile Service Manual

6. BCM AIRBAG CONTROL MODULE
----The BCM (airbag control module) (See
figure) is installed on the floor under the
heat exchanging radiator. The BCM
(Airbag control module) includes airbag
sensor, safety sensor, diagnosis circuit,
ignition controlling and driving circuit. It
receives the signal from airbag sensor and
determines whether to trigger the SRS
system.
----In case any collision accident happens and
causes the airbag to activate, do not use
the airbag computer again.
----The maintenance work (even if it is only
loosening the fastening bolts of the central
sensor assembly of the airbag) must be
carried out at least 5 minutes after turning
the ignition switch to "LOCK" position
and disconnecting the battery negative
cable.
7. WIRING AND CONNECTOR
The wirings of SRS system are all installed in
a yellow corrugated
connectors are all normal yellow. If by any
accident, the wiring has been loosened or the
connector damage, they must be repaired or
replaced according to related instruction.
8. SRS CONNECTOR
The connectors of SRS system are all yellow
in order to be identified from other
connectors.
The connectors of SRS system are facilitated
with special functions and specific designed
features to ensure high reliability. These
terminals are using durable gold-plated
terminals. The double locking plate locks the
electronic connection terminal mechanism,
which can prevent the terminal from sliding
out. As shown in the figure:
conduit, and the
T-66
Double
locking plate
Airbag connector