Chery automobile Service Manual page 269

race and observe whether it runs normally.
----Apply the lubricating grease on the hub spline
and the bearing neck, and then press the hub
into the bearing.
----Tighten three M6 bolts to fix the dust plate
with the tightening torque of 10N·m.
----Use the fuzz-free cloth to clean the working
surface of the brake disc. If there is oil stain
on the surface, clean it with ethanol. And
then install the brake disc.
----Rotate the brake disc and observe whether
there is lock or abnormal noise.
OVERHAUL OF THE LOWER CONTROL
ARM
Check the status of damage, crack and bend of
the control arm.
Replace the ball joint and the rubber cover of the
lower control arm if they loose or wear.
Replace the front housing of the lower control
arm
----Press out the front housing of the lower
control arm. (shown as the illustration)
----Apply the lubricating grease before installing
the front housing of the lower control arm.
----Press in the front housing of the control arm.
(shown as the illustration)
M-20