Removal And Installation Of The Front Wheel Bearing - Chery automobile Service Manual

REMOVAL AND INSTALLATION OF THE FRONT WHEEL BEARING

Removal:
----Remove the front brake disc and the dust
plate, and then extrude the hub.
----Remove the spring retainer of both sides and
extrude the wheel bearing. (shown as the
illustration)
----Pull out the bearing inner race. Use the puller
with hoop to pull the wheel bearing inner
race out of the wheel hub. (shown as the
illustration)
Inspection:
----After all the components are disassembled,
please clean and check them, and replace
them with new ones if necessary.
----If the working surface of the brake disc wears
severely beyond the specified value (wearing
limit: 10.0mm), please replace it with a new
one.
Caution: Do not exceed the wearing limit.
----If the dust plate is severely deformed, please
replace it with a new one.
----If the hub spline wears severely and looses,
please replace it with a new one.
----If the spring retainer is not available, please
replace it with a new one.
----If the wheel bearing is damaged, please
replace it with a new one.
Installation and adjustment
----Set the outer spring retainer first, apply the
lubricating grease onto the wheel bearing
holder and then press the bearing down to the
limit position, as shown in the illustration,
and fix the inner spring retainer last.
----Adjust the split positions of the inner and
outer spring retainer so as to make their
difference 180°. Then rotate the bearing inner
M-19