Chery automobile Service Manual page 317

-- Install the brake shoe and parking brake lever, and
reassemble the return spring, as shown in the
figure.
-- Fix the parking brake cable on the parking brake
lever, and install the brake shoe on the brake
wheel cylinder.
-- Install the lower return spring, and adjust the
return spring and the spring of wedge-shaped
block.
-- Install the brake drum and rear wheel hub bearing.
-- Forcefully step on the brake pedal several times to
make the friction lining of brake in place.
REPLACEMENT OF FRICTION LINING OF BRAKE
-- Check whether there are some oil stains on the
surface of friction lining of brake, and use an
abrasive cloth to grind off it, if any. Replace the
friction lining of drum brake in case it is worn to
its limit, and replace it together with the brake
shoe when replacing.
Caution: The friction lining of brake shall be
from the same manufacturer and with
the same quality when it is replaced
with new one.
INSPECTION OF REAR WHEEL DRUM BRAKE
-- Measure the inner diameter of brake drum, as
shown in the figure.
Standard inner diameter: 200 mm
Service limit: 201 mm
In case there are some scratches and indentions on
the inner circle of brake drum after use, reprocess
the inner circle on a lathe.
Caution: The inner diameter shall not be greater
than the service limit when the inner
circle is reprocessed on the lathe.
P-13