Removal, Installation & Adjustment Of Engine Hood - Chery automobile Service Manual

REMOVAL, INSTALLATION & ADJUSTMENT OF ENGINE HOOD
REMOVAL
------Brace engine hood to remove washer
nozzle of windshield.
------Loosen the four screws securing engine
hood and hinges, two each side, while
the other operator removes the hood.
INSTALLATION:
------Install in the reverse order of removal.
ADJUSTMENT:
------To ensure an even clearance of 4
0.5mm, consistent height and smooth
transition around the hood, the hinge is
designed with slot in it to make final
adjustment of engine hood.
------In making transverse adjustment of the
hood, loosen the bolt as shown in the
figure to move the hood till the desired
value is reached.
------In making vertical adjustment of the
front part of the hood, adjust the pin with
the rubber stopper to keep front fender
and engine hood on the same level.
EXTERIOR ACCESSORIES
S-4