Chery automobile Service Manual page 98

Caution
·Connecting the wrong check connector terminal may possibly cause malfunction.
Carefully connect the specified terminal only.
1 Short the check connector terminal F/P body GND using a jumper wire.
2 Turn the ignition switch to ON position to operate the fuel pump.
3 Pressurize the system in this way for at least 5minites to be sure of no leakage.
·If there is fuel leakage, inspect the fuel hose, hose clamps, and fuel pipe sealing surface,
and replace as necessary.
4 After repair, assemble the system and repeat Steps 1 to 3.
Fuel tank removal/installation
Warning
·Repair a fuel tank that has not been properly steam cleaned can be dangerous.
Explosion or fire may cause death or serious injury. Always properly steam clean
a fuel tank before repairing it.
·Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious
injuries or death and damage. Fuel can also irritate skin and eyes. To prevent
this, do not damage the sealing surface of the fuel pump until when removing or
installing.
Caution
·Disconnecting/connecting the quick release connector without cleaning it may
possibly cause damage to the fuel pipe and quick release connector. Always clean
the quick release connector joint area before disconnecting/connecting using a
cloth or soft brush, and make sure that it is free of foreign material.
1 Lever the vehicle.
2 Complete the
3 Disconnect the negative battery cable.
4 Remove the fuel pump unit.
5 Siphon the fuel from the fuel tank.
6 Remove the middle pipe.
7 Remove in the order indicated in the table.
8 Install in the reverse order of removal.
Complete the
9
Before repair procedure
After repair procedure .
F-15