Chery automobile Service Manual page 374

DISASSEMBLY OF COLUMN C:
Remove the decorative cap, after that loosen
the lock nut between the internal lining and
column C.
Use a plug extraction tool to remove the
fastening plug in the headliner of the car
ceiling.
Other worker will remove the headliner and
pull it out from the rear door opening.
Assembly:
The steps are the reverse of disassembly. The
installing angle for the retractor assembly of
left/right front safety belt is 0º, the tightening
torque of the locking bolt is 50±10N·m, the
tightening torque of the fastening bolt for
adjusting the sliding guide rail is 24±5N·m ,
the tightening torque of the guide ring
fastening bolt is 50±10N·m. The installing
angle for the retractor assembly of left/right
rear safety belt is 30º, and the tightening torque
is 50±10N·m.
Note: Appropriate measures should be taken to
avoid dirtying the car during disassembly and
assembly.
S-27