Chery automobile Service Manual page 291

Assemblage of the Steering Mechanism
Preparation:
Clean all components in clean organic solvents before assemblage, then dry them with a
blower
Precaution: Be careful during operation. The organic solvent is flammable and
explosive, keep it away from any tiny sparks. Otherwise, it may lead hurt
or even death.
Precaution: Make sure to wear the goggles while using the compressed air.
Lay the clean components separately and avoid the collision or scratch.
Replace all the oil seal, seal loop and seal ring. Apply the white special grease on the
O-ring and oil seal of the seal sections.
Get the replacing components ready every component must be qualified before
assemblage.
Precaution: When replace, all the set bolt, adjusting screw, seal component, lock nut
and the other components must be conformed to the technical specification
of Chery and can not be substituted arbitrarily.
Get the clean MoS
during assembling.
Precaution: If the unclean grease is used, the seal components would be damaged or
scratched, which will impact the steering power and result in accidents.
Assemblage
Precaution: Do not twist any seal components during assembling.
Lithium lubricating grease or the same performance grease ready
2
Illustration 19
Install the rack Refer to Illustration 19
·Apply MoS
Lithium lubricating grease on the
2
rack of the rack assy 31
·Protect the rack with the vinyl tape. Fix the
rack piston assy in the oil cylinder hull, then pull
out the vinyl tape and check if it is complete.
N-14